(1) Used 800 Ton Schuler Complete Blanking Line

Capactity: 800 Ton
Usable Energy @ 20 SPM: 519 US ton x inch
Main Drive: DC, Braking, SCR reverse parallel
Drive Method: top drive, eccentric
Drive Power: Approx 290 HP
Micro Inching: main drive and low energy
Number of Points: 4
Overload Protection: 2”
Speed: 20 - 80 SPM continuous
Speed: 30 SPM single stroke
Stroke Length: 12”
Shut Height: 50” (SDAU)
Max Weight of Upper Die: 60,000#
Slide Adjustment: 5.9”
Slide Adjustment Speed: 2 IPM
Slide Area: 204” lr x 108” fb
Number of Slide Clamps: 18
Windows: 106” fb x 78.7” high
Front Opening between Oil Catchers: 204” + 1.6”

Equipped with:
(2) Rolling Bolsters (front - back)
MB Plate Height: 8”
Bolster Height Above Floor: 31.6”
Clamping Surface: 204” fb x 108” lr
Max Bolster Load: 180,000#
(4) Counter Balance Cylinders (20 Tons Each)
Max Press Height: 27.5’

Coil Feed Line:
Coil Car:
80,000# x 80” Wide Capacity
Lifting Stroke: 30”

Uncoiler:
80,000# x 80” Wide Capacity
Coil OD: 80”
Coil ID: 21.65” - 24.8”
Coil Width: 16” - 80”

Threader
Cropping Device: 84” Width
Roller Table: 112.2” Approx

Straightener:
Thickness Capacity: .020” - .100”
12 Roll plus 1 Supplementary Roll
(2) Pinch Rolls: 6.3”
(12) Straightening Rolls: 1.9”
Pinch Roll Lift Stroke: 3.9” Approx
Block Cleaning Lift Stroke: 8”

Loop Equipment: 6 Pairs of light barriers

Roll Feed:
(2) Feed Rollers: 6.3”
Feed Roll Lift Stroke: 1”
Strip Feed Speed Max: 656 ft/min
Feed Length Adjustable: .004 - 294 inch

Micro Feeder & Nibbler

Oscillating Die:
Swivel Angle: +/- 30 degrees
Knife Length: 91.8”
Height Above Passline: 16.2”
Height Below Passline: 32.87”

Stacking Device in Feed Direction:
Telescopic Conveyor
(feed direction) Approx: 79”
Width Adjust Range Approx: 11.8”
Blank Length to NC Stops: 9 - 165”
Blank Length to Coffin Stops” 6 - 165”
Blank Width: 16 - 80”
Stack Height Required; 24” (including pallet height)
Lift Table Carrying Weight: 33,000#

Side Stacking Device: (non operational)