(1) Used 30 Stand Stand Yoder Rollforming Line

Line Includes:

Line Direction: Right to Left

20,000 Lbs x 36” American Steel Line Uncoiler
Model: 1000
Year: 1982
Coil Capacity: 20,000 lbs
Coil Width: 36”
Mandrel Width: 42”
Coil OD: 60”
Coil Car

100 Ton 4-Post Hydraulic Pre-Notch Press
Bed / Slide : 120” L-R x 80” F-B
Approximate Distance Between Posts: 45”
Approximate Stroke: 12”
Approximate Open Daylight: 20”

36” x .080” CHS Press Mounted Servo Feeder
Model: MX-336
Year: 2014
Pilot Release
Free Standing Control Cabinet
Allen Bradley Panelview Plus 600

24 Stand Yoder (Two 12 Stand Bases)
Year: 1970
Base One - (11) Stands on (12) Stand Base
Spindle Diameter: 2.5”
Roll Space: 36”
Horizontal Centers: 18”
Vertical Adjustment: 5” - 10”

NOTE:
- This section has spindles free spinning. There is a thread up drive motor to load material into rollformer.
- Stands 2-12 has 3 3/4” riser block under each outboard and gear box.
- Stands 3-12 has a 1” riser block on top of outboard and gear box.

75 HP Main Drive Motor into Gearbox reducer to create proper torque.

Base Two - (12) Stands on (12) Stand Base
These Stands Driven
Spindle Diameter: 2.5”
Roll Space: 36”
Horizontal Centers: 18”
Vertical Adjustment: 5” - 10”

NOTE:
- Stands 13 - 19 has 3 3/4” riser block under each outboard and gear box.
- Stands 13 - 19 has a 2 1/2” riser block on top of outboard and gear box.
- Stands 20-24 has 3 3/4” riser block under each outboard and gear box, 2 1/2” riser block on top of outboard and gear box with special equal gearing on the outboards.

Base Three - (4) on (9) Stand Base
These Stands Driven
Year: 1964
Spindle Diameter: 3”
Roll Space: 36”

NOTE:
- 3 3/4” riser block under each outboard and gear box.
- Stands 13 - 19 has a 2 1/2” riser block on top of outboard and gear box.
- Stands 20-24 has 3 3/4” riser block under each outboard and gear box, 2 1/2” riser block on top of outboard and gear box with special equal gearing on the outboards.

4-Post Hydraulic Piercing Press
Table Area: 48” L-R x 38” F-B
Between Posts: 38” x 38”
Daylight Opening: 18”
Stroke: 1”
Excel Controls
EPS Hydraulic Pump

Base Four - (2) Stand
Spindle Diameter: 3”
Roll Space: 36”

4-Post Hydraulic Cutoff Press
Table Area: 48” x 48”
Between Posts: 38” x 38”
Stroke: 1.5”
Daylight Opening: 23”