(1) Used 500 Ton Heim Straight Side Four Point Press (Remanufactured in 2020)

Capacity: 500 Ton
Rating Point: 1/4” above bottom
Drive Style: Eccentric Geared
Bed Size: 100” lr x 70” fb
Ram Size: 100” lr x 70” fb
Stroke Length: 6”
Adjustment: 10” (powered)
Shut Height Above Bed: 21”
Shut Height Above Bolster: 15”
Speed: 25 SPM

EQUIPPED WITH:
HT-1500 Air Clutch / Brake
LINK 5100 APC Control
Recalculating Oil Lubrication System
Air Counter Balances
Hydraulic Overloads

Overall Height: 225"

Currently Wired: 460/3/60

This Press Was Completely Remanufactured By Heim in 2020

Remanufactured As Follows:

- (4) NEW bullgears
- (4) NEW bullgear pins
- NEW pinion gear w/ bearings and new 1st reduction set gears
- NEW clutch / brake unit
- (4) NEW adjusting screws
- (4) NEW lower sockets in knuckle boxes
- (4) NEW connecting rod bushings
- NEW Flywheel shaft w/ bearings
- NEW Flywheel bearings / repair flywheel bore as needed
- NEW LINK 5100 APC (console style w/ locking casters)
- NEW 16 input die protection module
- NEW Auto rec. lube system
- NEW Slide adustment air motor / shaft bearings.
- One set of 24" inch light curtains mounted in press window
- NEW 8 point gibbing with post remachined
- Remachine slide and bed faces
- Repair crown bores and reline bore
- Remove and replace bent inner crown wall
- Check / reuse auto counter balance system
- Stone any high-spots of newly installed bolster plate
OPTION:
Convert press to a (4) point Hydralulic Overload Sysyem. Maintain current shut height of 21" over bed and 15" over bolster.